• 0402 290 290
  • 24 Hour Emergency Service

5 Infallible Techniques for a Leaky Pipe Restoration

plumbergranville pipe-leaks

Minor inconveniences are definitely the basic signs of plumbing catastrophe initiations. A full-blown plumbing element will always start from a minor dilemma, when not addressed earlier, this can cause devastation to the entire system. A leaky pipe, be it a pinhole or a completely shattered water pipe, are signs of initiating plumbing catastrophe. Your pipes might be deteriorated causing them to bang or hammer or there might be an initiating corrosion. Both can cause your pipes to leak or burst. But when minor leaks happen, you do not have to call and engage with a professional plumber. You can actually solve this on your own with the help of your plumbing background, investigation skills and these reliable techniques.
 

  1. Use a hose clamp

This tip is suitable for DIYs or for homeowners who choose to fix the leak on their own. In this situation, you would need some rubber patch to help your restore your leaky pipes. You can purchase one of these in some home improvement stores. To initiate the restoration process, wrap the rubber patch around the leaky area, make sure that the leak is completely wrapped allowing no passage for water escapade. After wrapping it, tighten the hose clamp on top of the rubber to secure the rubber and to avoid unfastening. Now, you can already screw on the tightening element. You have to secure the alignment of both the rubber patch and the hose clamp to the leaky area. Yet this is not a permanent solution to your plumbing problem. This can only last for a few years and you would definitely need to replace the pipe to ensure the wellbeing of your plumbing system.
 

  1. Tape the pipe

Taping the pipe can be one way of restoring your leaky pipes. But this method is only applicable for pinholes and small leaks. This is no longer suitable for large bursts and breaks. The first thing you should do is to, of course, locate the leak. After such, turn the shut-off valve off and dry the pipe body especially on the leaky area. You can now start taping the pipe with electrical tape. Make sure to tape both sides of the pipe to avoid the tape from easily peeling off. After that, look for a permanent solution as this can only last for a short time.
 

  1. Epoxy compound utilisation

If the leak is located on joints and fittings, using the aforementioned temporary solutions wouldn’t solve your problem. Instead, you can utilise an epoxy compound available in many hardware and stores. Epoxy compounds are usually used by many homeowners in plugging off a pipe leak. This is usually activated by kneading two components together. After mixing these components, patch it directly to the hole or flatten it on your palm before patching it to the leaky area. Let it cure according to its curing time before turning the shut-off valve back on.
 

  1. Rubbing a compound stick

A compound stick is available in our plumbing market. The necessity to turn the shut-off valve off would depend on the size of the leak. This method can be completed by simply swabbing the stick’s tip on the leaky area until completely plugging it off.
 

  1. Joint tightening

When leaks occur in the joint area, sometimes it is caused by loose joints or pipe fitting that are not properly installed. In this case, you would just have to tighten the joints with the help of a wrench.